30 in stock
The CH340 series of chips are a full-speed USB device that emulates a standard serial interface, with speeds from 50bps to 2Mpbs.The chip supports 5V and 3.3V, selectable via a jumper (included).You can easily use it for serial communication to your MCUs (Arduinos,RPis,etc).Each Board is tested by our experts at Nexgen Gadgets before dispatching to ensure reliable & flawless working.
₹82.60 Price Including GST
30 in stock
CompareUSB To TTL Converter USB To RS232 TTL CH340G Converter Module Adapter
Specifications :=-
USBasp is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed, and thats make it low cost USB programmer.
The Programmer works on USB port and can be used with Laptops. Software is compatible with Windows Vista and Windows 7. High speed programming and does’t require external power.
TTP226 8-Way Capacitive Touch Sensor / Switch Module is based on a touch-sensing IC enabling capacitive touch switch mode. In the normal state, the module output is low, low power consumption. When a finger touches the corresponding position, the module output high, if not touched for 12 seconds, switch to low-power mode.
The MAX6675 performs cold-junction compensation and digitizes the signal from a type-K thermocouple. The data is output in a 12-bit resolution, SPI™-compatible, read-only format. This converter resolves temperatures to 0.25°C, allows readings as high as +1024°C, and exhibits thermocouple accuracy of 8LSBs for temperatures ranging from 0°C to +700°C. The MAX6675 is available in a small, 8-pin SO package
This is a dual axis high quality JoyStick Module . It can be used to sense movements in 2 directions(axes). It also has a inbuilt switch which can be activated by pressing the stick.Directional movements are simply two potentiometers – one for each axis. Pots are ~10k each.
With the help of this Joystick Module, you can measure position coordinates on the X and Y axis by moving the “hat”. It also contains a switch that is press-able by pushing the “hat”.It also contains a switch that is press-able by pushing the “hat” down. Similar to the XBOX controller.The X and Y axes are two 10k potentiometers which control 2D movement by generating analog signals. When the module is in working mode, it will output two analog values, representing two directions. This module uses the 5V power supply, and value, when reading through analog input, would be about 2.5V, a value will increase with joystick movement and will go up till maximum 5V; the value will decrease when the joystick is moved in other direction till 0V.
Select at least 2 products
to compare
Battery Pack 6.4v 6000 Mah LIFEPO4 Rechargable For Solar 
3S 10A 18650 Battery Charger BMS With Protection 11.1V 
Flame Sensor Or Fire Ignition Sensor Module 4 pin 
There are no reviews yet.