36 in stock
This is a good quality Single Sided Glass Epoxy FR4 PCB board. It is also known as Copper Clad Board with 1-Sided Glass Epoxy. This board can be used to build your own circuit boards, breakout boards, DIY board, and other Industrial boards and applications. This board is made of high-quality Glass Epoxy laminate and has the size of 3X2 inches.
₹31.86 Price Including GST
36 in stock
Compare
Specifications:-
Material: Glass Epoxy (Single Side)
Size: 3 Inches X 2 Inches
Approx Thickness – 2 mm
Back Side Deep Green masking
Single side Copper
Package Include :- 1 x Copper clad board (3X2 Inch)
This is a good quality Single Sided Glass Epoxy FR4 PCB board. It is also known as Copper Clad Board with 1-Sided Glass Epoxy. This board can be used to build your own circuit boards, breakout boards, DIY board, and other Industrial boards and applications. This board is made of high-quality Glass Epoxy laminate and has the size of 6X4 inches.
The PAM8403 5V Two-channel Stereo is a 3W+3W, class-D audio amplifier. Allowing it to achieve high-quality sound reproduction. The new filterless architecture allows the device to drive the speaker directly, requiring no low-pass output filters, thus saving system cost and PCB area. With the same numbers of external components, the efficiency of the PAM8403 is much better than that of Class-AB cousins. It can extend the battery life, which makes it well-suited for portable applications.
This is an LM2596 DC-DC buck converter step-down power module with high-precision potentiometer for adjusting output voltage, capable of driving a load up to 3A with high efficiency. When the output current required is greater than 2.5A(10W) an external heatsink is suggested. Use on board switch to change display measurement between the input or output voltage, and a LED indicate which value(IN/OUT) is being measured. This setting is stored even after power off. Voltmeter can be turned off, just keep the switch pressed for 1 second and leave it. Adjust Input and output voltage measurement error offset – long press switch for 4 seconds or more, the digital display flashes, then short press the button to change the value of output (values range from -0.5 to 0.5, the unit is V), a positive number indicates an upward calibration, negative downward calibration. Now press the button again for adjust input offset in same manner.
This tiny Flame sensor infrared receiver module ignition source detection module is Arduino compatible can use to detect flame or wavelength of the light source within 760nm~1100nm also useful for Lighter flame detect at the distance 80cm. Greater the flame, farther the test distance.It has the Detect angle of 60 degrees and very sensitive to flame spectrum. It produces the one channel output signal at D0 terminal for further processing like an alarm system or any switching system. The sensitivity is adjustable with the help of blue potentiometer given on the board.
Select at least 2 products
to compare
COB LED Light 2.4 Watt Module 12V waterproof White 
6S 15A 22V BMS PCB Protection Board 
LDR 5 mm Light Dependent Resistance 
There are no reviews yet.