Out of stock
The DC-DC Adjustable Step-Down Converter Module has large power, high efficiency, low-ripple. With power indicator, on-board voltmeter. The voltmeter can calibrate automatically. The measure can be changed between input and output voltage, with indicator. The voltmeter can also be shutdown. this DC-DC 5A Buck Converter uses a connection terminal for easy wiring. The output voltage is adjustable from 1.25 to 35 V from an input of 4 to 38 V. Note that the input voltage must be at least 1.5 V higher than the required output voltage.
₹289.10 Price Including GST
Out of stock
DC-DC 5A Buck ConverterFeatures:
Module Properties: 5A High Power 75W DC-DC adjustable step-down module
Input voltage: DC 4.0 ~ 38V
Output voltage: DC 1.25V ~ 36V continuously adjustable ( the input voltage must be higher than the output voltage 1.5V )
Output current: max 5A, recommended for use in the 4.5A.
Output power: up to 75W, more than 50W, Please enhance heat dissipation
Voltmeter error: ± 0.05V
Measure range: 0 ~ 40V ( please ensure that the input voltage is 4.5V or more)
Conversion efficiency: up to 96%
Load regulation: S (I) ≤ 0.8%
Voltage Regulation: S (u) ≤ 0.8%
With overheat protection and short circuit protection
DC-DC 5A Buck Converter Dimensions: 6.6 * 3.9 * 1.8cm
This is an LM2596 DC-DC buck converter step-down power module with high-precision potentiometer for adjusting output voltage, capable of driving a load up to 3A with high efficiency. When the output current required is greater than 2.5A(10W) an external heatsink is suggested. Use on board switch to change display measurement between the input or output voltage, and a LED indicate which value(IN/OUT) is being measured. This setting is stored even after power off. Voltmeter can be turned off, just keep the switch pressed for 1 second and leave it. Adjust Input and output voltage measurement error offset – long press switch for 4 seconds or more, the digital display flashes, then short press the button to change the value of output (values range from -0.5 to 0.5, the unit is V), a positive number indicates an upward calibration, negative downward calibration. Now press the button again for adjust input offset in same manner.
MT3608 2A Max DC-DC Step Up Power Module Booster
Specifications:
2V to 24V input voltage with output boost 5V to 28V adjustable
Maximum output current: 2A
Input voltage: 2V ~ 24V
Maximum output voltage: > 5V – 28V
Efficiency: > 93%
Input voltage should not exceed the maximum input voltage
Peak current output current should not more than 2A
Output voltage should always be higher than Input voltage
PCB Size: 36 mm * 17 mm * 14 mm
It is 18650 Mobile power bank Battery Charge, Discharge, Protection & Boost Circuit board module.You can make your own power bank using this module. It can charge up to 4 batteries in parallel.Can show the battery charge & discharge status with two mode on-board LED’.(Blink& Standby)Module comes with protection function, Overcharge protection, Over-discharge protection, Over current protection.Intelligent Overcharge protection system automatically stops charging once the connected device is fully charged. Stable Output voltage and current.
Select at least 2 products
to compare
Air Humidifier Ultrasonic Mist Maker Fogger Water Fountain 24v 
Zero PCB 4X4 Inch General Purpose tinned Board 
There are no reviews yet.