Out of stock
Product Name : PCB Board;Hole Dia(Approx) : 1.5mm / 0.05″
Hole Pitch(Approx) : 44.5mm / 1.75″;Size(Approx) : 7 x 5cm / 2.8″ x 2″(L*W)
Thickness(Approx) : 1.2mm /0.04″;Color : Copper Tone
Weight : 20g
Package Content : 1pc x Universal PCB Board
₹29.50 Price Including GST
Out of stock
Prototype Paper Copper PCB Matrix Circuit Board 5x7cm
Brand new and high quality Circuit Board
Material: Single Side Copper Printed Circuit Board
Hole Dia: about 1mm Circuit Board
Hole pitch: standard 2.54mm Circuit Board
Circuit Board with 432 holes
Circuit Board For point to point DIY soldering.
Color: As the picture show
Item size: 71*51*1mm Circuit Board
This is a 2 Channel 5V Relay interface board, Be able to control various appliances, and other equipments with large current. It can be controlled directly by Microcontroller(Arduino , 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic) .
MT3608 2A Max DC-DC Step Up Power Module Booster
Specifications:
2V to 24V input voltage with output boost 5V to 28V adjustable
Maximum output current: 2A
Input voltage: 2V ~ 24V
Maximum output voltage: > 5V – 28V
Efficiency: > 93%
Input voltage should not exceed the maximum input voltage
Peak current output current should not more than 2A
Output voltage should always be higher than Input voltage
PCB Size: 36 mm * 17 mm * 14 mm
12V PAM8610 Mini Class D Digital Power Amplifier Board 2 x15w Dual Channel Stereo.The amplifier circuit board designed using the official standard, the chip is used in the selection of US imports original Longding micro Class D amplifier chip. The chip is strong or not strong you can go to check the information under it.Good product chip and the majority of music lovers would share, which is our consistent philosophy! The amplifier with ultra-high efficiency, large power, in the case of 12V power supply can output 10W + 10W of power, the chip without heat sink, also has overheated, over-current protection function,the function can be said to be very powerful.The board has a switching function, the SW shorted turns off the power amplifier.
This is an LM2596 DC-DC buck converter step-down power module with high-precision potentiometer for adjusting output voltage, capable of driving a load up to 3A with high efficiency. When the output current required is greater than 2.5A(10W) an external heatsink is suggested. Use on board switch to change display measurement between the input or output voltage, and a LED indicate which value(IN/OUT) is being measured. This setting is stored even after power off. Voltmeter can be turned off, just keep the switch pressed for 1 second and leave it. Adjust Input and output voltage measurement error offset – long press switch for 4 seconds or more, the digital display flashes, then short press the button to change the value of output (values range from -0.5 to 0.5, the unit is V), a positive number indicates an upward calibration, negative downward calibration. Now press the button again for adjust input offset in same manner.
Select at least 2 products
to compare
2S 10A 7.4V Lithium Iion battery BMS Protection Board 
18650 Battery Charger module 5V 1A Module for PowerBank 
There are no reviews yet.