Out of stock
₹247.80 Price Including GST
Out of stock
TPA3118 PBTL Mono Digital Amplifier Board 60W
Working Voltage: DC 8-24V
Power Output: 60W
Applicable Speaker Impedance: 4-8 ohm
PCB Board Size: 45 x 35 mm
Weight: 14 gm.
Sound quality is very good by using this module.
Mono digital audio power amplifier chip.
High output and low power consumption.
Applicable speaker impedance: 4-8 ohm(8 ohm is the best).
The power amplifier circuit board designed using the official standard. the chip uses a selection of US imports original Longding micro Class D amplifier chip. Good product chip is necessary and the majority of music lovers to share. this is our consistent philosophy! The amplifier with ultra-high efficiency. large power. in the case of 12V power supply can output 10W + 10W of power. the chip without fins. but also with overheating. over-current protection function. the function can be said to be very powerful.
PAM8403 is a small digital amplifier chip, high-definition sound quality highlights the advantages of digital chips, circuit using the most reasonable peripheral configuration, power supply filtering is upgraded to 470uf (some sellers are less did not even 100uf capacitance) 1.6mm glass sheet, the real amplifier board did the most detailed, high-fidelity sound output 3W + 3W, is a rare good product enthusiasts amplifier, potentiometer using original anti-meter body, life expectancy up to 15 years, potentiometer with switch can cut off the power supply directly counter clockwise, Listing has been received by the buyer!
This is an LM2596 DC-DC buck converter step-down power module with high-precision potentiometer for adjusting output voltage, capable of driving a load up to 3A with high efficiency. When the output current required is greater than 2.5A(10W) an external heatsink is suggested. Use on board switch to change display measurement between the input or output voltage, and a LED indicate which value(IN/OUT) is being measured. This setting is stored even after power off. Voltmeter can be turned off, just keep the switch pressed for 1 second and leave it. Adjust Input and output voltage measurement error offset – long press switch for 4 seconds or more, the digital display flashes, then short press the button to change the value of output (values range from -0.5 to 0.5, the unit is V), a positive number indicates an upward calibration, negative downward calibration. Now press the button again for adjust input offset in same manner.
This tiny module is perfect for charging single cell 3.7V 1 Ah or higher LiPo cells such as 16550s that don’t have their own protection circuit.Based around the TP4056 charger IC and DW01 battery protection IC this module will offer 1A charge current then cut off when finished.Futhermore when the battery voltage drops below 2.4V the protection IC will switch the load off to protect the cell from running at too low of a voltage – and also protects against over-voltage and reverse polarity connection (it will usually destroy itself instead of the battery) however please check you have it connected correctly the first time.
For Bulk Quantity Please call US:- +91 9830150448
The TP4056 1A Li-Ion Lithium Battery Charging Module – Micro B USB is a 3.7V lithium battery charger module has on-board Micro USB interface. With Micro-USB onboard connector, you can directly connect to computer USB port for battery charging. If USB is not available you can use an external source voltage at IN+/IN- pads, great for DIY projects. It is small size and lightweight.
Select at least 2 products
to compare
Black Plastic Storage Box Case Holder For Battery 1x 18650 With Wire Leads 
Battery Pack 12.6v 2600 Mah Lithium Ion Rechargeable 3C 
DC Buck Converter 5V3A USB Output Module 
There are no reviews yet.