Shop
Showing 586–600 of 612 results
-
IoT & Wireless, Modules & Sensors
SIM 800L GSM GPRS MODULE MICRO SIM CARD
The SIM800L module supports quad-band GSM/GPRS network, available for GPRS and SMS message data remote transmission. The SIM800L communicates with microcontroller via UART port, supports command including 3GPP TS 27.007, 27.005 and SIMCOM enhanced AT Commands. It also has built-in level translation, so it can work with microcontroller of higher voltage than 2.8V default. Besides, the board also supports A-GPS technique which is called mobile positioning and gets position by mobile network. This features make it can also be a tracker module.
SKU: CE-M061 -
Components, SMD
SMD NE555 Timer IC Module SOP8 Integrated Circuit
SMD NE555 Timer IC Module SOP8 Integrated Circuit.Low Turn Off Time Maximum Operating Frequency Greater than 500kHz Timing From Microseconds To Hours Operates In Both Astable and Monostable Modes Adjustable Duty Cycle TTL Compatible Temperature Stability of 0.005% Per °C Model: NE555 Type: SOP8 Voltage Supply: 4.5-16V High Output Current can Source or Sink 225mA
SKU: CE-S-NE555 -
Developments Boards, IoT & Wireless, Modules & Sensors
SN65HVD230 CAN Communication Module Bus Transceiver
Developments Boards, IoT & Wireless, Modules & SensorsSN65HVD230 CAN Communication Module Bus Transceiver
SN65HVD230 can be used under high interference environment. The device has the ability to send and receive good at different rates.Its main features are as follows: Fully compatible with ISO11898 standard; High input impedance. allowing 120 nodes; Low current standby mode. the typical current of 370A; Signal transfer rate up to 1Mb / s;Thermal protection. open circuit failure protection function; With anti-instantaneous interference protection bus; Slope control. reduce radio frequency interference (RFI);Differential receiver with a wide range of anti-common-mode interference. electromagnetic interference (EMI) capabilities.
SKU: CE-M065 -
Components
SN74HC595N, 8-Bit Shift Register ICs
Features:
- 8-bit
- Logic Family : HC
- Logical Function : Shift Register
- Operating Supply Voltage (Typ) : 5V
- Output Type : 3-State
- Package Type : DIP
- Propagation Delay Time : 265ns
- Operating Temp Range : -40C to 125C
- Operating Supply Voltage (Min) : 2V
- Operating Supply Voltage (Max) : 6V
You Will Get :
- SN74HC595N IC = 1
- 16 Pin IC Base = 1
SKU: CE-IC004 -
-
Developments Boards
ST-Link V2 Mini STM8 STM32 Simulator Download Programmer
The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.
- internal motherboard, U disk shell using aluminum alloy installation, convenient to carry, safe and reliable!
- interface definition on the shell directly tagging, be clear at a glance, convenient and practical!
- 5 V, 3.3 V available at the same time, convenient for you to link the 5 V and 3.3 V target board
- shell characters using laser laser, laser engraving, never fade off! Permanent clear!
- internal motherboard with 500 ma self recovery fuse, completely protect your expensive computer motherboard!
- The LED indicator light, convenient you always observes the working state of the ST cc-link V2!
- Distribution 4 with dupont line, let you can easily cope with different target plate line order!
- Use anti-static bag packaging, automatic sealing machine sealed packaging, safe and reliable, does not fear the electrostatic, not afraid of water!
SKU: CE-P001 -
-
Developments Boards
STM32F103C8T6-ARM-STM32-Minimum-System-Development-Board
This is STM32F103C8T6 Minimum System Board Microcomputer STM32 ARM Core Board. This board is low cost Minimum System Development Board for ARM Microcontroller STM32F103C8T6. Board is suitable for learners that want to learn STM32 microcontroller with ARM Coretex-M3 32-bit core.
SKU: CE-D002 -
Developments Boards
STM8S103F3P6 STM8 Minimum System Development Board
STM8S core board of the highlights: The development board using MicroUSB cable supply, compatible with smart phone lines, data lines is simple and easy to get, but not USB MINI line-powered, USB MINI line is not easy to find, has been gradually phased out. Other manufacturers of products are used in MINI-USB port, this is not applicable for customers. Low price, user-friendly design, a full set of data, allowing you to save money, save time, effort, worry!
SKU: CE-D004 -
Batteries & Chargers, Circuits Boards & PCB
TP4056 Micro USB 1A 18650 Lithium Battery Charger Module
The TP4056 1A Li-Ion Lithium Battery Charging Module – Micro B USB is a 3.7V lithium battery charger module has on-board Micro USB interface. With Micro-USB onboard connector, you can directly connect to computer USB port for battery charging. If USB is not available you can use an external source voltage at IN+/IN- pads, great for DIY projects. It is small size and lightweight.
SKU: CE-M029-W -
-
