5V 2 Amp Power Supply Board 220V AC to 5V DC
123 in stock
5V 2 Amp Power Supply SMPS board. Best for your mobile charger & other 5V regulated items. Input 220V AC & output Fixed 5 Volt.
₹76.70 Price Including GST
123 in stock
Compare5V 2 Amp Power Supply Board 220V AC to 5V DC
5V 2Amp Output
LED Indications
Small Size – 40 x 40 x 15 mm Approx
Easy To Use
Note:- Please Do not Touch Any part Of this circuit when it powered on. The best way for putting it inside a non-conductive material box like Plastic
Based on 0 reviews
Be the first to review “5V 2 Amp Power Supply Board 220V AC to 5V DC”
You may also like…
Related products
-
Batteries & Chargers, Circuits Boards & PCB, Power Supply
DC 3V to 5V USB OUTPUT STEP UP POWER MODULE
Batteries & Chargers, Circuits Boards & PCB, Power SupplyDC 3V to 5V USB OUTPUT STEP UP POWER MODULE
DIY a mobile power supply, only need one battery, you can output 5V voltage for your phone, MP3, MP4, PSP charger, very easy.In order to power your electronic devices when your device needs 5V power supply, when you only have lithium battery, this module can be directly step-up to 5V, solve your problems.
SKU: CE-M018 -
Batteries & Chargers, Battery holder & Box, Circuits Boards & PCB, Power Supply
Lithium Battery Charging Board TP 4056 Micro USB with Protection
Batteries & Chargers, Battery holder & Box, Circuits Boards & PCB, Power SupplyLithium Battery Charging Board TP 4056 Micro USB with Protection
This tiny module is perfect for charging single cell 3.7V 1 Ah or higher LiPo cells such as 16550s that don’t have their own protection circuit.Based around the TP4056 charger IC and DW01 battery protection IC this module will offer 1A charge current then cut off when finished.Futhermore when the battery voltage drops below 2.4V the protection IC will switch the load off to protect the cell from running at too low of a voltage – and also protects against over-voltage and reverse polarity connection (it will usually destroy itself instead of the battery) however please check you have it connected correctly the first time.
For Bulk Quantity Please call US:- +91 9830150448
SKU: CE-M029 -
Batteries & Chargers, Circuits Boards & PCB, Power Supply
LM 2596 DC Buck Converter Module
This is an LM2596 DC-DC buck converter step-down power module with high-precision potentiometer for adjusting output voltage, capable of driving a load up to 3A with high efficiency. When the output current required is greater than 2.5A(10W) an external heatsink is suggested. Use on board switch to change display measurement between the input or output voltage, and a LED indicate which value(IN/OUT) is being measured. This setting is stored even after power off. Voltmeter can be turned off, just keep the switch pressed for 1 second and leave it. Adjust Input and output voltage measurement error offset – long press switch for 4 seconds or more, the digital display flashes, then short press the button to change the value of output (values range from -0.5 to 0.5, the unit is V), a positive number indicates an upward calibration, negative downward calibration. Now press the button again for adjust input offset in same manner.
SKU: CE-M064
There are no reviews yet.