50 in stock
The DHT11 Temperature And Humidity Sensor Module with LED is a small humidity and temperature sensor that you can connect to your Arduino and get readings for temperature and humidity in the environment.
₹94.40 Price Including GST
50 in stock
ComparePackage Include:-
1X DHT 11 Module
You May Like This
DHT21 Capacitive Digital Temperature & Humidity Sensor sensor is one of the commonest from the range of DHT temperature sensors and boasts a relatively high-temperature measurement accuracy of 0.5oC in 0.1oC steps with a relative humidity accuracy of +/- 3%. It has only 3 wires, including power and ground, meaning only one digital pin is required to interface it to a microcontroller. For Arduino development platforms the sensor is very well supported by the DHT library available from the Arduino Playground website.
DHT-11 Digital Temperature And Humidity Sensor is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2 seconds, so in your code please use sensor reading interval at 2 seconds or more. Compared to the DHT22, this sensor is less precise, less accurate and works in a smaller range of temperature/humidity, but its smaller and less expensive
DHT22 capacitive humidity sensing digital temperature and humidity module is one that contains the compound has been calibrated digital signal output of the temperature and humidity sensors. Application of a dedicated digital modules collection technology and the temperature and humidity sensing technology, to ensure that the product has high reliability and excellent long-term stability.
TTP226 8-Way Capacitive Touch Sensor / Switch Module is based on a touch-sensing IC enabling capacitive touch switch mode. In the normal state, the module output is low, low power consumption. When a finger touches the corresponding position, the module output high, if not touched for 12 seconds, switch to low-power mode.
The Keyes KY-040 rotary encoder is a rotary input device (as in knob) that provides an indication of how much the knob has been rotated AND what direction it is rotating in.It’s a great device for stepper and servo motor control. You could also use it to control devices like digital potentiometers..
The CH340 series of chips are a full-speed USB device that emulates a standard serial interface, with speeds from 50bps to 2Mpbs.The chip supports 5V and 3.3V, selectable via a jumper (included).You can easily use it for serial communication to your MCUs (Arduinos,RPis,etc).Each Board is tested by our experts at Nexgen Gadgets before dispatching to ensure reliable & flawless working.
XT60 Bullet Connectors Male Female Pair 
Rotary Encoder Module Brick Sensor arduino KY-040 
HX711 Weighing Sensor Dual-Channel 24 Bit Precision A/D Module Pressure Sensor 
There are no reviews yet.