Shop
Showing 241–255 of 620 results
-
-
Modules & Sensors
IR Line Following Sensor Module- TCRT 5000 4 Pin
It Adopts TCRT5000 photoelectric sensor and comparator which is easy to use with good stability and anti-interference ability. Perfect for black & white line detection for smart car. Black line for low level output and white line for high level output. The Operating Voltage is 5V. Tested range of 2cms-9cms.
SKU: CE-M0145 -
Components, Tools & DIY, Transistors
IRF3205 Mosfet Fast Switching Power Transistor N
IRF3205 is an N-Channel HEXFET Power MOSFET that is mainly based on Advanced Process Technology and used for fast switching purpose. International Rectifier has introduced this device with the aim to generate extremely low on-resistance per silicon area.
SKU: IRF3205 -
-
Circuits Boards & PCB, Developments Boards, Holders Wire connector Cables & Screw
Jumper Wire 20 cm 40 Pcs Lot All Types
Circuits Boards & PCB, Developments Boards, Holders Wire connector Cables & ScrewJumper Wire 20 cm 40 Pcs Lot All Types
A jump wire (also known as jumper wire, or jumper) is an electrical wire, or group of them in a cable, with a connector or pin at each end (or sometimes without them – simply “tinned”), which is normally used to interconnect the components of a breadboard or other prototype or test circuit, internally or with other …
SKU: CE-T055 -
Components
L293D Motor driver IC with Base
L293D Description. L293D is a typical Motor driver or Motor Driver IC which allows DC motor to drive on either direction. L293D is a 16-pin IC which can control a set of two DC motors simultaneously in any direction. It means that you can control two DC motor with a single L293D IC
SKU: CE-IC002 -
Modules & Sensors, Motor Drives & controllers
L293D Motor Driver Shield for Arduino
This L293D Motor Driver Shield for Arduino is probably one of the most versatile on the market and features 2 servo and 4 motor connectors for DC or stepper motors. That makes it a great shield for any robotic project.
This Arduino compatible motor Driver shield is a full-featured product that it can be used to drive 4 DC motor or two 4-wire steppers and two 5v servos. It drives the DC motor and stepper with the L293D, and it drives the servo with Arduino pin9 and pin10.
L293D is a monolithic integrated, high voltage, high current, 4-channel driver. Basically, this means using this chip you can use DC motors and power supplies of up to 36 Volts, that some pretty big motors and the chip can supply a maximum current of 600mA per channel, the L293D chip is also what’s known as a type of H-Bridge. The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. a motor.
The shield contains two L293D motor drivers and one 74HC595 shift register. The shift register expands 3 pins of the Arduino to 8 pins to control the direction of the motor drivers. The output enables the L293D is directly connected to PWM outputs of the Arduino.
SKU: CE-M0172
