113 in stock
5V 2 Amp Power Supply SMPS board. Best for your mobile charger & other 5V regulated items. Input 220V AC & output Fixed 5 Volt.
₹76.70 Price Including GST
113 in stock
Compare5V 2Amp Output
LED Indications
Small Size – 40 x 40 x 15 mm Approx
Easy To Use
Note:- Please Do not Touch Any part Of this circuit when it powered on. The best way for putting it inside a non-conductive material box like Plastic
This is an LM2596 DC-DC buck converter step-down power module with high-precision potentiometer for adjusting output voltage, capable of driving a load up to 3A with high efficiency. When the output current required is greater than 2.5A(10W) an external heatsink is suggested. Use on board switch to change display measurement between the input or output voltage, and a LED indicate which value(IN/OUT) is being measured. This setting is stored even after power off. Voltmeter can be turned off, just keep the switch pressed for 1 second and leave it. Adjust Input and output voltage measurement error offset – long press switch for 4 seconds or more, the digital display flashes, then short press the button to change the value of output (values range from -0.5 to 0.5, the unit is V), a positive number indicates an upward calibration, negative downward calibration. Now press the button again for adjust input offset in same manner.
This tiny module is perfect for charging single cell 3.7V 1 Ah or higher LiPo cells such as 16550s that don’t have their own protection circuit.Based around the TP4056 charger IC and DW01 battery protection IC this module will offer 1A charge current then cut off when finished.Futhermore when the battery voltage drops below 2.4V the protection IC will switch the load off to protect the cell from running at too low of a voltage – and also protects against over-voltage and reverse polarity connection (it will usually destroy itself instead of the battery) however please check you have it connected correctly the first time.
For Bulk Quantity Please call US:- +91 9830150448
It is 18650 Mobile power bank Battery Charge, Discharge, Protection & Boost Circuit board module.You can make your own power bank using this module. It can charge up to 4 batteries in parallel.Can show the battery charge & discharge status with two mode on-board LED’.(Blink& Standby)Module comes with protection function, Overcharge protection, Over-discharge protection, Over current protection.Intelligent Overcharge protection system automatically stops charging once the connected device is fully charged. Stable Output voltage and current.
Select at least 2 products
to compare
Li-Ion 18650 Rechargeable Battery 1200MAH Wired 
Fast Quick Charger QC3.0 DC-DC Step Down Buck Converter 
There are no reviews yet.